Quartz Guard PRO-9H is base on Si02 with a pencil hardness of 9H and a temperature rating up to 600°C. This new generation hybrid coating combines both organic and inorganic components resulting in a permanent scratch resistant super hydrophobic coating that leaves the paintwork with an incredible high gloss finish that last for years.
Due to its hybrid chemistry, Quartz Guard can also be used on plastic trims, stainless steel and chrome. With its high temperature rating Quartz Guard offers maximum protection against break dust pitting on wheels either powder coated or lacquered.
Quartz Guard Pro is an extremely powerful fast curing coating and should only be applied if you understand the application process.
- Strong chemical bonding
- Pencil hardness 9H
- Temperature rating up to to 600°C
- Chemical resistant
- UV & weather resistant
- Protection against bird dropping & tree sap
- Long term protection
- Super high gloss finish
- Easy clean
This is a professional coating and should only be attempted if you are familiar with the application of Ceramic Coatings.
Any paint correction like swirl marks & scratches should be removed prior to the application
The surface must be thoroughly cleaned, dry and free of grease, silicone, wax or polish residues. To prepare the surface you can either use our Pre-Clean, Isopropanol or Panel Wipe. The minimum application temperature is 5°C – maximum 25°C ( do not use in direct sunlight). For metal, any corrosion spots must be removed prior to the application. This product is solvent based, so compatibility with the surface should always be tested.
Apply a small amount of product to an application pad and spread out as thinly as possible using ( horizontal the vertical strokes)only coat an area of around 1mtr squared at a time making sure that the surface is completely coated, then remove excess coating immediately with a new microfiber cloth using light pressure only, make sure any reside is removed or streaking may result. Discard the microfiber cloth after 30mins and replace with a new microfiber cloth.
To apply multiple layers, wait for a minimum of 5 mins and a maximum of 30 minutes between coats. A high layer thickness improves abrasion resistance and increases gloss level. Recommended layer thickness is between 600nm and 3µm.
Dust dry in around 5-15 mins and cab be exposed to water after around 4-6 hours. The complete formation of layer hardness and chemical resistance is achevied after 5-7days.
Coverage approximately 20m² per 100ml per coat, this can vary depending on the type of substrate.
Large 4 x 4 – 50ml
Average size car- 30ml
Wheels – 15ml
Only logged in customers who have purchased this product may leave a review.